Security Commands 924
radius-server attribute 25
Use the radius-server attribute 25 command to globally enable the switch to
send the RADIUS Class attribute as supplied by the RADIUS server in
accounting messages sent to the accounting server.
Syntax
radius-server attribute 25 include-in-access-req
no radius-server attribute 25 include-in-access-req
Default Configuration
By default, the switch sends the Class attribute to the accounting server.
Command Mode
Global Configuration
User Guidelines
The switch sends the value supplied by the RADIUS server in the Class
attribute. The Class attribute may be up to 16 octets in length
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#radius-server attribute 25 include-in-access-req
radius-server attribute 31
Use the radius-server attribute 31 command to alter the format of the MAC
address sent to the RADIUS server when authenticating using 802.1X MAC
based authentication. Use the no form of the command to return the MAC
address format to the default.
To Next Page
Loading...
Need help?
General
