Layer 3 Routing Commands 1277
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router-af)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan
10 filter-list 1 in
neighbor inherit peer
To configure a BGP peer to inherit peer configuration parameters from a peer
template, use the neighbor inherit peer command. To remove the
inheritance, use the no form of this command.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-id ] ] | autodetect
interface interface-id} inherit peer template-name
no neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface interface-id} inherit peer template-name
• ip-address—The neighbor’s IPv4 address.
• ipv6-address [interface interface-id]—The neighbor’s IPv6 address. If the
neighbor’s IPv6 address is a link local address, the local interface must also
be specified.
• autodetect interface interface-id – The VLAN routing interface on which
the neighbor’s link local IPv6 address is auto detected.
• template-name—The name of the peer template whose peer configuration
parameters are to be inherited by this neighbor.
Default Configuration
No peer configuration parameters are inherited by default.
Command Mode
BGP Router Configuration mode, IPv4 Address Family Configuration mode
To Next Page
Loading...
Need help?
General
