Layer 2 Switching Commands 678
Example
The following example displays how to set the DiffServ operational mode to
active.
console(Config)#diffserv
drop
Use the drop command in Policy-Class-Map Configuration mode to specify
that all packets for the associated traffic stream are to be dropped at ingress.
NOTE: This command is not available on the N1500 Series switches.
Syntax
drop
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to specify that matching packets are to
be dropped at ingress.
console(config-policy-classmap)#drop
mark cos
Use the mark cos command in Policy-Class-Map Configuration mode to
mark all packets for the associated traffic stream with the specified class of
service value in the user priority field of the 802.1p header. If the packet does
not already contain this header, one is inserted.
NOTE: This command is not available on the N1500 Series switches.
To Next Page
Loading...
Need help?
General
