Layer 3 Routing Commands 1606
Syntax
ipv6 pim register-threshold threshold
no ipv6 pim register-threshold
• threshold — The threshold rate (Range: 0–2000 Kbps).
Default Configuration
The default threshold rate is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim register-threshold 250
ipv6 pim rp-address
Use the ipv6 pim rp-address command to statically configure the RP address
for one or more multicast groups. The optional keyword override indicates
that if there is a conflict, the RP configured with this command prevails over
the RP learned by BSR. Use the no form of this command to remove the RP
address for one or more multicast groups.
Syntax
ipv6 pim rp-address rp-address group-address/prefixlength [ override ]
no ipv6 pim rp-address rp-address group-address/prefixlength
• rp-address — An RP address.
• group-address — The group address to display.
• prefixlength — This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–128)
To Next Page
Loading...
Need help?
General
