Layer 2 Switching Commands 539
AE Selector = 1
AE Protocol = 3260
AE Priority = priority configured for iSCSI PFC (the VPT value above). This
TLV is sent in addition to any Application Priority TLV information received
from the configuration source. If the configuration source is sending iSCSI
application priority information, it is not necessary to enable iscsi cos to send
the iSCSI Application Priority TLV.
Example
In the following example, iSCSI is globally enabled.
console(config)#iscsi enable
iscsi target port
Use the iscsi target port command in Global Configuration mode to
configure iSCSI port(s), target addresses and names. To delete iSCSI port(s)
or target ports, use the no form of this command.
Syntax
iscsi target port tcp-port-1 [tcp-port-2.… tcp-port-16
[address ip-address]
[name targetname]
no iscsi target port tcp-port-1 [tcp-port-2.… tcp-port-16 [address ip-address]
• tcp-port —TCP port number or list of TCP port numbers on which iSCSI
target(s) listen to requests. Up to 16 TCP ports can be defined in the
system in one command or by using multiple commands.
• ip-address—IP address of the iSCSI target. When the no form is used, and
the tcp port to be deleted is one bound to a specific IP address, the address
field must be present.
• targetname—iSCSI name of the iSCSI target. The name can be statically
configured; however, it can be obtained from iSNS or from sendTargets
response. The initiator MUST present both its iSCSI Initiator Name and
the iSCSI Target Name to which it wishes to connect in the first login
request of a new session or connection. The target name can consist of any
printable character except for a question mark as the first character. The
name can contain embedded blanks if enclosed in double quotes.
To Next Page
Loading...
Need help?
General
