Layer 3 Routing Commands 1288
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10
prefix-list test in
neighbor prefix-list (IPv6 Address Family
Configuration)
In IPv6 address family configuration mode, the neighbor prefix-list command
specifies an IPv6 prefix list to filter routes received from or advertised to a
given peer.
Syntax
neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
no neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
• ip-address—The neighbor’s IPv4 address.
• prefix-list-name—The name of an IP prefix list.
• ipv6-address—The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified. This
command is available in IPv6 address family mode.
• interface vlan vlan-id—The local interface/VLAN ID over which the IPv6
neighbor can be reached. Range: 1-4093.
• in—Apply the prefix list to advertisements received from this neighbor.
• out—Apply the prefix list to advertisements to be sent to this neighbor.
Default Configuration
No prefix list is configured.
Command Mode
IPv6 Address Family Configuration mode
To Next Page
Loading...
Need help?
General
