Switch Management Commands 2105
link Enable/Disable switch level Link Up/Down trap flag.
multiple-users Configure multiple users login traps.
ospf Enable/Disable OSPF Traps.
ospfv3 Enable/Disable OSPFv3 Traps.
pim Enable/Disable traps for protocol-independent
multicast.
port-security Enable/Disable switch level Maclock Violation trap
flag.
snmp Enable SNMP traps.
spanning-tree Configure spanning tree traps.
vrf Specify VPN Routing/Forwarding instance.
vrrp Enable/Disable VRRP trap.
snmp-server engineID local
Use the snmpserver engineID local command in Global Configuration mode
to specify the Simple Network Management Protocol (SNMP) engine ID on
the local device.
To remove the configured engine ID, use the no form of this command.
Syntax
snmp-server engineID local {engineid-string | default}
no snmp-server engineID local
• engineid-string — The character string that identifies the engine ID.
The engine ID is a concatenated hexadecimal string. Each byte in
hexadecimal character strings is two hexadecimal digits. Each byte can
be separated by a period or colon. (Range: 6-32 characters)
• default — The engineID is created automatically, based on the device
MAC address.
Default Configuration
The engineID is generated using the switch MAC address.
Command Mode
Global Configuration mode
To Next Page
Loading...
Need help?
General
