Layer 3 Routing Commands 1631
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the NSSA so that summary LSAs are not
advertised into the NSSA.
console(config-router)#area 20 nssa no-summary
area nssa translator-role
Use the area nssa translator-role command in Router OSPF Configuration
mode to configure the translator role of the NSSA.
Syntax
area area-id nssa translator-role {always | candidate}
no area area-id nssa translator-role
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
• always — The router assumes the role of the translator when it becomes a
border router.
• candidate — The router to participate in the translator election process
when it attains border router status.
Default Configuration
The default role is candidate.
Command Mode
Router OSPF Configuration mode.
To Next Page
Loading...
Need help?
General
