Layer 3 Routing Commands 1494
show ip policy
Use the show ip policy command to display the route maps used for policy
based routing on the router interfaces.
Syntax
show ip policy map-name
• map-name—The name of a specific route map.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
console#show ip policy
Interface Route map
Vl10 pbr-map
show ip protocols
Use the show ip protocols command to display a summary of the
configuration and status for each unicast routing protocol. The command
lists all supported routing protocols, regardless of whether they are currently
configured or enabled.
Syntax
show ip protocols [vrf vrf-name]
• vrf-name—The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
To Next Page
Loading...
Need help?
General
