Layer 2 Switching Commands 281
show service-acl interface
This command displays the status of LLPF rules configured on a particular
port or on all the ports.
Syntax
show service-acl interface {interface-id | all}
•
interface-id—
An Ethernet interface identifier or a port channel interface
identifier.
See
Interface Naming Conventions
for interface
representation.
Default Configuration
UDLD is blocked by default. No other protocol is blocked by default.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
console#show service-acl interface te1/0/1
console(config-if-Te1/0/1)#show service-acl interface te1/0/1
Service-acl Interface Te1/0/1
Protocol Mode
--------------- ----------
CDP Disabled
VTP Disabled
DTP Disabled
UDLD Enabled
PAGP Disabled
SSTP Disabled
ALL Disabled
To Next Page
Loading...
Need help?
General
