Layer 3 Routing Commands 1760
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the information in VLAN 11’s virtual
interface tables.
console#show ipv6 ospf interface vlan 11
IP Address..................................... 11.11.11.11
ifIndex........................................ 1
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 10 (computed)
OSPF Mtu-ignore................................ Disable
OSPF cannot be initialized on this interface.
show ipv6 ospf interface brief
Use the show ipv6 ospf interface brief command to display brief information
for the IFO object or virtual interface tables.
Syntax
show ipv6 ospf interface brief
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
To Next Page
Loading...
Need help?
General
