Switch Management Commands 2098
User Guidelines
This command has no user guidelines.
Example #1
console#show trapflags
Authentication Flag............................ Enable
Auto-copy-sw Flag.............................. Enable
Dot1q Flag..................................... Enable
Link Up/Down Flag.............................. Enable
Port-security violation Flag................... Enable
Multiple Users Flag............................ Enable
Mbuf Threshold Flag............................ Enable
CPU Threshold Flag............................. Enable
Spanning Tree Flag............................. Enable
PoE Traps...................................... Enable
VRRP trap...................................... Enable
ACL Traps...................................... Enable
BGP Traps...................................... Disable
DVMRP Traps.................................... Disable
OSPFv2 Traps................................... Disable
PIM Traps...................................... Disable
OSPFv3 traps................................... Disable
CP Traps....................................... Disable
Example #2
console#show trapflags ospf
OSPFv2 traps................................... Disabled
errors:
all....................................... Disabled
lsa:
all....................................... Disabled
overflow:
all....................................... Disabled
retransmit:
all....................................... Disabled
state-change:
all....................................... Disabled
snmp-server community
Use the snmp-server community command in Global Configuration mode to
set up the community access string to permit access to the SNMP protocol.
To remove the specified community string, use the no form of this command.
To Next Page
Loading...
Need help?
General
