Layer 3 Routing Commands 1348
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec and Global Config modes
User Guidelines
If the vrf argument is specified, the community list information pertaining to
that VRF is displayed.
Command History
Introduced in version 6.2.0.1 firmware. Updated in the version 6.3.0.1
firmware.
Example
console(config)#show ip bgp community-list test
BGP table version is 0, local router ID is 65.1.1.1
Status Codes: s suppressed, * valid, > best, i - internal
Origin Codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPref Path Origin
------------------ --------------- ---------- --------- ------------- ------
show ip bgp extcommunity-list
Use the show ip bgp extcommunity-list command to display all the permit
and deny attributes of the given extended community list. If the list-number
is specified, the output is displayed that matches the given list-number; else
all the lists are displayed.
Syntax
show ip bgp extcommunity-list list-number
• list-number — A standard extended community list number (0 to 99).
Default Configuration
No extended community lists are configured by default.
To Next Page
Loading...
Need help?
General
