Layer 3 Routing Commands 1610
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
There are no user guidelines for this command.
Example
console(config)#show ipv6 pim
PIM Mode....................................... Sparse
Interface Interface-Mode Operational-Status
--------- -------------- ------------------
Vl1 Enabled Operational
show ipv6 pim bsr-router
Use the show ipv6 pim bsr-router command to display the bootstrap router
(BSR) information.
Syntax
show ipv6 pim bsr-router { candidate | elected }
• candidate—Show the IPv6 PIM candidate bootstrap router information.
• elected—Show the IPv6 elected PIM bootstrap router information.
Default Configuration
There is no default configuration for this command.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
Field descriptions are shown in the following table.
To Next Page
Loading...
Need help?
General
