Switch Management Commands 2184
Command Modes
User Exec mode on the stack master. Unit prompt on the stack member.
User Guidelines
This command is available in User Exec mode on the master unit serial port
and from the Unit prompt on member unit serial ports. The user need not be
currently connected over the serial port to connect to another unit.
The stack member being connected to must be up and running and
connected as part of the stack.
This command is an alias for the
exit
command.
Example
Example 1:
To disconnect a remote session to the stack master established from a stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#
Stack-Master#quit
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
Example 2:
To disconnect a remote session to the stack master established from stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#exit
Stack-Master>quit
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
reload
Use the reload command to reload stack members.
The reload command checks for stack port errors prior to reloading stack
members and after the check for unsaved configuration changes. If stack port
errors are found, a message is displayed.
Syntax
reload [stack–member–number]
To Next Page
Loading...
Need help?
General
