Dell N1100-ON User Manual

Dell EMC Networking CLI 180
Loopback Interface
Multicast
show ipv6 route
preferences
Shows the preference value associated with
the type of route.
PE
show ipv6 route summary Displays a summary of the routing table. PE
show ipv6 snooping
counters
Displays the RA guard dropped packet
counters.
PE
GC
show ipv6 traffic Shows traffic and statistics for IPv6 and
ICMPv6.
UE
show ipv6 vlan Displays IPv6 VLAN routing interface
addresses.
PE
traceroute ipv6 Discovers the routes that packets actually
take when traveling to their destination
through the network on a hop-by-hop basis.
PE
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
a. For the meaning of each Mode abbreviation, see Mode Types .
arp Enters the Interface Loopback configuration
mode.
GC
show interfaces loopback Displays information about configured
loopback interfaces.
PE
Command Description Mode
a
arp Adds an administrative scope multicast
boundary.
IC
ip mroute Creates a static multicast route for a source
range.
GC
ip multicast-routing Sets the administrative mode of the IP
multicast forwarder in the router to active.
GC
ip multicast ttl-threshold Applies a ttlvalue to a routing interface. IC
Command Description Mode
a

Dell N1100-ON Specifications

General

Brand	Dell
Model	N1100-ON
Category	Switch
Language	English