Layer 3 Routing Commands 1596
User Guidelines
The following fields are displayed.
Example
console#show ip pim rp mapping candidate
RP Address.................................... 192.168.10.1
Group Address.............................. 224.1.2.1
Group Mask................................. 255.255.0.0
Origin..................................... BSR
C-RP Advertisement Interval (secs)......... 60
Next Candidate RP Advertisement (hh:mm:ss). 00:00:15
If no RP Group mapping exists on the router, the following message is
displayed:
No RP-Group mappings exist on this router.
If no static RP Group mapping exists on the router, the following message is
displayed:
No Static RP-Group mappings exist on this router.
show ip pim statistics
Use the show ip pim statistics command to display the count of PIM sparse
mode received control packets per VLAN.
Syntax
show ip pim statistics [vlan vlan-id]
vlan-id — The VLAN for which PIM sparse mode statistics are displayed.
Default configuration
There is no default configuration for this command.
Field Description
RP Address Address of the RP
Group Address Address of the multicast group.
Group Mask Mask for the group address.
Origin Origin from where this group mapping is learned.
To Next Page
Loading...
Need help?
General
