EasyManuals Logo

Dell N1100-ON User Manual

Dell N1100-ON
2332 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1272 background imageLoading...
Page #1272 background image
Layer 3 Routing Commands 1272
Command Mode
BGP Router Configuration mode
IPv4 Address Family Configuration mode
User Guidelines
The VLAN interface must also be specified if a link-local address is specified.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10
description Test-System
neighbor ebgp-multihop
Use the neighbor ebgp-multihop command to configure BGP to form
neighborship with external peers that are not directly connected.
Syntax
neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface interface-id } ebgp-multihop hop-count
no neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetect
interface interface-id } ebgp-multihop hop-count
• ip-address — The neighbor’s IPv4 address. This is the IP address of the
neighbor on the connected link.
• ipv6-address — The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified. Valid in
IPv6 address family configuration mode.
•
interface
interface-id —The local VLAN routing interface over which the
IPv6 neighbor can be reached or is auto-detected. Use the vlan keyword
and a VLAN ID. Range 1-4093.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell N1100-ON and is the answer not in the manual?

Dell N1100-ON Specifications

General IconGeneral
BrandDell
ModelN1100-ON
CategorySwitch
LanguageEnglish

Related product manuals