Dell N1100-ON User Manual

Layer 2 Switching Commands 326
dhcp l2relay (Global Configuration)
Use the dhcp l2relay command to enable Layer 2 DHCP Relay functionality.
The subsequent commands mentioned in this section can only be used when
the L2-DHCP Relay is enabled. Use the no form of this command to disable
L2-DHCP Relay.
Syntax
dhcp l2relay
no dhcp l2relay
Default Configuration
DHCP L2 Relay is disabled by default.
Command Mode
Global Configuration.
User Guidelines
There are no user guidelines for this command.
Example
console(config)#dhcp l2relay
dhcp l2relay (Interface Configuration)
Use the dhcp l2relay command to enable DHCP L2 Relay for an interface.
Use the no form of this command to disable DHCP L2 Relay for an interface.
Syntax
dhcp l2relay
no dhcp l2relay
Default Configuration
DHCP L2Relay is disabled on all interfaces by default.

Dell N1100-ON Specifications

General

Brand	Dell
Model	N1100-ON
Category	Switch
Language	English