Switch Management Commands 2146
logging on
Use the logging on command in Global Configuration mode to control error
messages logging. This command globally enables the sending of logging
messages to the currently configured locations. To disable the sending of log
messages, use the no form of this command.
Syntax
logging on
no logging on
Default Configuration
Logging is enabled.
Command Mode
Global Configuration mode
User Guidelines
The logging process controls the distribution of logging messages to the
various destinations, such as the logging buffer, logging file, or syslog server.
Logging on and off for these destinations can be individually configured using
the logging buffered, logging file, and logging
server
global configuration
commands. However, if the logging on command is disabled, no messages are
sent to these destinations. In this case, only the console will continue to
receive logging messages.
Example
The following example shows how logging is enabled.
console(config)#logging on
logging protocol
Use this command to log messages in RFC5424 format, including time zone
and subsecond resolution time stamps. Use the no form of this command to
set the logging to the default format.
To Next Page
Loading...
Need help?
General
