Switch Management Commands 2192
Messages Checkpointed.....................6708
Bytes Checkpointed........................894305
Time Since Counters Cleared...............3d 01:05:09
Checkpoint Message Rate...................0.025 msg/sec
Last 10-second Message Rate...............0 msg/sec
Highest 10-second Message Rate............8 msg/sec
show cut-through mode
Use the show cut-through mode command to show the cut-through mode on
the switch.
Syntax
show cut-through mode
Command Mode
Privileged Exec, Global Configuration mode and all Configuration submodes
Default Configuration
This command has no default configuration.
User Guidelines
This command is not available on N1100-ON/N1500/N2000/N2100-
ON/N3000/N3100-ON switches.
Example
Console#show cut-through mode
Current mode : Enable
Configured mode : Disable (This mode is effective on next reload)
show hardware profile
Use the show hardware profile command to display the hardware profile
information for the 40G ports. The user can optionally specify an interface or
all 40G interfaces are displayed.
To Next Page
Loading...
Need help?
General
