Dell N1100-ON User Manual

Layer 3 Routing Commands 1742
no ipv6 router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
Use the following command to enable OSPFv3.
console(config)#ipv6 router ospf
maximum-paths
Use the maximum-paths command in Router OSPFv3 Configuration mode
to set the number of paths that OSPF can report for a given destination.
Syntax
maximum-paths maxpaths
no maximum-paths
• maxpaths — Number of paths that can be reported. (Range: 1-2)
Default Configuration
2 is the default value for maxpaths.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.

Dell N1100-ON Specifications

General

Brand	Dell
Model	N1100-ON
Category	Switch
Language	English