Layer 3 Routing Commands 1714
area default-cost (Router OSPFv3)
Use the area default-cost command in Router OSPFv3 Configuration mode
to configure the monetary default cost for the stub area. The operator must
specify the area id and an integer value between 1-16777215. Use the no form
of the command to return the cost to the default value. If the area has not
been previously created, this command creates the area and then applies the
default-cost.
Syntax
area area-id default-cost cost
no area area-id default-cost
• areaid — Valid area identifier.
• cost — Default cost. (Range: 1-16777215)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
area virtual-link
dead-interval
ipv6 ospf hello-
interval
redistribute
(OSPFv3)
show ipv6 ospf range
area virtual-link
hello-interval
ipv6 ospf mtu-
ignore
router-id show ipv6 ospf stub
table
area virtual-link
retransmit-interval
ipv6 ospf network show ipv6 ospf show ipv6 ospf virtual-
links
–––
show ipv6 ospf virtual-
link brief
To Next Page
Loading...
Need help?
General
