Layer 3 Routing Commands 1330
show bgp ipv6 neighbors advertised-routes
Use this command to display IPv6 routes advertised to a specific neighbor.
The format and field descriptions are the same as for show ip bgp neighbors
advertised-routes, except that the Network and Next Hop fields show IPv6
addresses. This command deprecates and replaces the show ipv6 bgp
neighbors advertised-routes command.
Syntax
show bgp ipv6 neighbors { ipv4-address | ipv6-address [ interface interface-id
] } advertised-routes
• ipv4-address—The IPv4 address of a BGP peer.
• ipv6-address [interface interface-id]—The IPv6 address of a BGP peer. If
the peer address is an IPv6 link local address, the interface that defines the
scope of the link local address must be given.
•
autodetect interface interface-id
—(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The interface
ID must be a VLAN routing interface.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration sub-
modes
User Guidelines
The following fields are displayed.
Field Description
BGP table version Each time phase 2 of the BGP decision process runs to
select new BGP routes, this number is incremented
Local router ID The IP address of the local router.
To Next Page
Loading...
Need help?
General
