Layer 3 Routing Commands 1710
Command Mode
User Exec mode, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
OSPF must be enabled for this command to display the virtual interface
information.
Example
The following example displays the OSPF Virtual Interface information in
the system.
console#show ipv6 ospf virtual-link brief
Hello Dead Retransmit Transit
Area ID Neighbor Interval Interval Interval Delay
------- -------- -------- -------- ---------- -------
0.0.0.2 5.5.5.5 10 40 5 1
timers pacing flood
Use the timers pacing flood command to adjust the rate at which OSPFv2
sends LS Update packets.
Use the no form of the command to return the timer pacing to the default
value.
Syntax
timers pacing flood milliseconds
no timers pacing flood
• milliseconds—The average time between transmission of LS Update
packets. The range is from 5 ms to 100 ms. The default is 33 ms.
Default Configuration
The default pacing between LS Update packets is 33 ms.
Command Mode
OSPFv2 Global Configuration mode
To Next Page
Loading...
Need help?
General
