Layer 3 Routing Commands 1812
Example
The following example configures VRRP on VLAN 15.
console#configure
console(config)#vlan 15
console(config-vlan)#interface vlan 15
console(config-if-vlan15)#ip address 192.168.5.1 255.255.255.0
console(config-if-vlan15)#vrrp 20
console(config-if-vlan15)#vrrp 20 ip 192.168.5.1
console(config-if-vlan15)#vrrp 20 mode
console(config)#ip routing
console(config)#ip vrrp
vrrp mode
Use the vrrp mode command in Interface Configuration mode to enable the
virtual router configured on an interface. Enabling the status field starts a
virtual router. Use the no form of the command to disable the virtual router.
Syntax
vrrp vr-id mode
no vrrp vr-id mode
• vr-id — The virtual router identifier. (Range: 1-255)
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the virtual router for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#vrrp 5 mode
To Next Page
Loading...
Need help?
General
