Layer 3 Routing Commands 1716
• interval—The period of time that an elected translator continues to
perform its duties after it determines that its translator status has been
deposed by another router. (Range: 0–3600)
Default Configuration
If no metric is defined, 10 is the default configuration.
The default role is candidate.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures not-so-stubby-area 10 as an NSSA.
console(config)#ipv6 router ospf
console(config-router)#area 10 nssa
The following example configures the metric value and type for the default
route advertised into the NSSA and configures the NSSA so that summary
LSAs are not advertised into the NSSA.
console(config-router)#area 20 nssa default-info-originate metric 250
metric-type 2 no-summary
area nssa default-info-originate (Router OSPFv3
Config)
Use the area nssa default-info-originate command in Router OSPFv3
Configuration mode to configure the metric value and type for the default
route advertised into the NSSA. The optional metric parameter specifies the
metric of the default route. The metric type can be comparable (nssa-external
1) or noncomparable (nssa-external 2). Use the no form of the command to
return the metric value and type to the default value
To Next Page
Loading...
Need help?
General
