Layer 3 Routing Commands 1505
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
This command displays statistics for the software IP stack, not the hardware
routing information.
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
Example
The following example displays IP route preferences.
console>show ip traffic
IpInReceives................................... 24002
IpInHdrErrors.................................. 1
IpInAddrErrors................................. 925
IpForwDatagrams................................ 0
IpInUnknownProtos.............................. 0
IpInDiscards................................... 0
IpInDelivers................................... 18467
IpOutRequests.................................. 295
IpOutDiscards.................................. 0
IpOutNoRoutes.................................. 0
IpReasmTimeout................................. 0
IpReasmReqds................................... 0
IpReasmOKs..................................... 0
IpReasmFails................................... 0
IpFragOKs...................................... 0
IpFragFails.................................... 0
IpFragCreates.................................. 0
IpRoutingDiscards.............................. 0
IcmpInMsgs..................................... 3
IcmpInErrors................................... 0
IcmpInDestUnreachs............................. 0
IcmpInTimeExcds................................ 0
IcmpInParmProbs................................ 0
IcmpInSrcQuenchs............................... 0
To Next Page
Loading...
Need help?
General
