Layer 2 Switching Commands 756
When the mode is changed to rapid-pvst, version 0 STP BPDUs are no longer
transmitted and version 2 RSTP-PV BPDUs that carry per-VLAN information
are transmitted on the VLANs enabled for spanning-tree. If a version 0 BPDU
is seen, RSTP-PV reverts to sending version 0 BPDUs.
RSTP-PV embeds support for STP-PV Indirect Link Rapid Convergence and
Direct Link Rapid Convergence. There is no provision to enable or disable
these features in RSTP-PV.
Example
The following example configures the spanning-tree protocol to MSTP.
console(config)#spanning-tree mode mst
spanning-tree mst configuration
Use the spanning-tree mst configuration command in Global Configuration
mode to enable configuring an MST region by entering the multiple
spanning-tree (MST) mode.
Syntax
spanning-tree mst configuration
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
For two or more switches to be in the same MST region, they must have the
same VLAN mapping, the same configuration revision number and the same
name.
Example
The following example configures an MST region.
console (config)#spanning-tree mst configuration
console (config-mst)#instance 1 add vlan 10-20
To Next Page
Loading...
Need help?
General
