Layer 2 Switching Commands 578
Command History
Implemented in version 6.3.0.1 firmware. Example updated in 6.4 version.
Example
console#show keepalive
Keepalive Service.............................. Enabled
Transmit Interval.............................. 10
Retry Count.................................... 3
show keepalive statistics
Use the show keepalive statistics command to display the loop protect status
for one or all interfaces.
Syntax
show keepalive statistics {interface-id | all}
•
interface-id
— Displays the statistics for the specified Ethernet (Physical)
interface.
•
all
— Displays statistics for all interfaces.
Default Configuration
There is no default configuration.
Command Mode
Privileged Exec mode and all configuration sub modes
Transmit Interval The transmission interval in seconds.
Retry Count The number of times a keepalive packet
must be seen before a looped state is
declared.
Field Description
To Next Page
Loading...
Need help?
General
