C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 145
2. From the SPEEDS menu, scroll and select EPower Speed.
Figure 208: SPEEDS Menu – EPower Speed
3. From the EPOWER SPEED menu, set the speed when in an emergency power condition.
Figure 209: EPOWER SPEED Menu
4. Scroll right and press Save.
13.4 Terminal Speed
Terminal speed sets the speed of the car while on inspection and within the configured soft
limit distance of a terminal floor. If speed is increased, the car runs faster when approaching
the terminal floor. If the speed is decreased, the car runs slower.
The adjustment range is from 0-30 fpm.
• Default = 15 fpm
• Units of Measure = fpm
The following procedure describes how to set the terminal speed.
1. Navigate to MAIN MENU | SETUP | SPEEDS. See Figure 55.
2. From the SPEEDS menu, scroll and select Terminal Speed.
Figure 210: SPEEDS Menu – Terminal Speed
To Next Page
General
