C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 255
4. From the DEFAULT S-CURVE? menu, select if restoring original S-Curve.
Figure 466: DEFAULT S-CURVE? Menu
5. From the DEFAULT S-CURVE? menu, select Yes to default S-Curve.
NOTE: If not defaulting S-Curve, select NO to back out.
The system automatically defaults all parameters. See Figure 463.
6. When the system has completed defaulting all parameters, the DEFAULTING PARAMS
menu displays Parameters Defaulted. SeeFigure 464.
29.17.3 Default Run Timers
The user has the option to restore the original run timers.
The following procedure describes how to select default run timers.
1. Navigate to MAIN MENU | SETUP | MISCELLANEOUS. See Figure 58.
2. From the MISCELLANEOUS menu, scroll and select Default. SeeFigure 460.
3. From the DEFAULT menu, scroll and select Default Run Timers.
Figure 467: DEFAULT Menu – Default Run Timers
4. From the DEFAULT RUN TIMERS? menu, select if restoring original run timers.
Figure 468: DEFAULT RUN TIMERS? Menu
5. From the DEFAULT RUN TIMERS? menu, select Yes to default run timers.
NOTE: If not defaulting run timers, select NO to back out.
Only the Learned floor values are defaulted. See Figure 463.
6. When the system has completed defaulting all parameters, the DEFAULTING PARAMS
menu displays Parameters Defaulted. See Figure 464.
To Next Page
General
