C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 273
32.10 Disable Construction Overspeed
Disable construction overspeed enables or disables the construction overspeed settings.
The following is an example of enabling or disabling the dis. const. overspeed.
1. Navigate to MAIN MENU | SETUP | SAFETY. See Figure 54.
2. From the SAFETY menu, scroll and select Disable Construction Overspeed.
Figure 519: SAFETY Menu – Disable Construction Overspeed
3. From the DISABLE CONSTRUCTION OVERSPEED menu, scroll and select if the disable
construction overspeed is enabled or disabled.
Figure 520: DISABLE CONSTRUCTION OVERSPEED Menu
4. Scroll right and press Save.
32.11 ETSL
During normal conditions, the normal terminal stopping device stops the car at a certain
landing within a set speed and distance. In case of emergencies where the normal terminal
stopping device fails, the emergency terminal stopping device stops the car according to the set
parameters within the reduced stroke buffer.
32.11.1 Enable ETSL
The ETSL enables or disables the emergency terminal safety limit.
1. Navigate to MAIN MENU | SETUP | SAFETY. See Figure 54.
2. From the SAFETY menu, scroll and select ETSL.
Figure 521: SAFETY Menu – ETSL
To Next Page
General
