C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 269
2. From the SAFETY menu, scroll and select Lock Clip.
Figure 505: SAFETY Menu – Lock Clip
3. From the LOCK CLIP menu, set the time of the lock.
Figure 506: LOCK CLIP Menu
4. Scroll right and press Save.
32.4 Inspection ODL
Inspection speed is the speed the car travels while in Inspection Mode. When the speed of the
car is greater than the normal inspection speed, an inspection overspeed fault occurs. The
debounce limit is set to give the brakes time to slow down the car to the maximum normal
inspection speed or below. If the speed of the car is still greater than the normal inspection
speed, a fault occurs.
The following is an example of setting the inspection ODL.
1. Navigate to MAIN MENU | SETUP | SAFETY. See Figure 54.
2. From the SAFETY menu, scroll and select Inspection ODL.
Figure 507: SAFETY Menu – Inspection ODL
3. From the INSPECTION ODL menu, enter the inspection debounce limit.
Figure 508: INSPECTION ODL Menu
To Next Page
General
