C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 261
2. From the GROUP SETUP menu, scroll and select Swing Call Mask.
Figure 482: GROUP SETUP Menu – Swing Call Mask
3. From the HALL SWING MASK menu, scroll and select the cars set for swing operation.
Figure 483: HALL SWING MASK Menu
4. Scroll right and press Save.
30.5 Stay Active in Group
When a car is setup to stay active in the group, the car can be operated by any riser in the
system during swing operation. The setup for inputs is required. If the inputs are not setup for
the controller, see section 30.1 Configuring Swing Operation Input.
The following procedure describes how to configure the car to stay active in the group.
1. Navigate to MAIN MENU | SETUP | SWING. See Figure 61.
2. From the Swing menu, scroll and select Stay In Group.
.
Figure 484: SWING Menu – Stay In Group
3. From the STAY IN GROUP menu, scroll and select On.
Figure 485: STAY IN GROUP Menu
4. Scroll right and press Save.
To Next Page
General
