C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 323
Status of the MR board NTS output
Status of the CT Escape Hatch input
Status of the CT Car Safeties input
Status of the CT Inspection input
Status of the Front Gate switch input
Status of the Rear Gate switch input
Status of the Front Door Zone input
Status of the Rear Door Zone input
Status of DIP 1-8 switches
Status of the Hoistway Access Inspection input
Status of the IC Stop switch input
Status of the Fire stop switch input
Status of the IC Inspection input
Status of DIP 1-8 switches
34.8 Load Weighing Status
The load weighing status displays the weight and torque of the car. See C4 Load Weighing
Device document for more information.
34.9 E-Power Status
The E-Power status displays if the car is running off emergency power.
The following procedure describes how to view which car is on emergency power. If the
command is off, then the car is not running on emergency power.
1. Navigate to MAIN MENU | STATUS | E-POWER STATUS. See Figure 49.
2. From the E-POWER COMMAND menu, view the cars running on emergency power.
Figure 643: E-POWER COMMAND Menu
To Next Page
General
