EasyManuals Logo
Home>Xerox>All in One Printer>WorkCentre 5225

Xerox WorkCentre 5225 Service Manual

Xerox WorkCentre 5225
1457 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #497 background imageLoading...
Page #497 background image
February, 2008
2-474
WorkCentre 5225, 5230
035-713, 035-714
Launch Version
Status Indicator Raps
035-713 Fax Protocol RAP
BSD-ON:16.1/17.1
No response signal was returned from the receiving Fax after the FTT (Failure To Train) signal
was sent.
Procedure
Fax phone line may also carry a DSL (Digital Subscriber Line) internet signal, but this is not
supported by the hardware. Fax requires an analog only phone line (can be used for voice
only).
035-714 Fax Protocol RAP
BSD-ON:16.1/17.1
A DCN (Disconnect) signal was returned from the receiving Fax to the NSC/DTC (Non-Stan-
dard Facilities Command/Digital Transmit Command) signal sent from the Fax controller for
one of the following:
Incorrect password
No originals for polling
Paper jam on the receiving Fax
Procedure
There is a problem with the receiving Fax. Ask customer to cancel the job and resend.

Table of Contents

Other manuals for Xerox WorkCentre 5225

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 5225 and is the answer not in the manual?

Xerox WorkCentre 5225 Specifications

General IconGeneral
Maximum print sizeA3 (297 x 420 mm)
Internal memoryNo MB
TypeDigital copier

Related product manuals