Xerox WorkCentre 5225 Service Manual

February, 2008
4-133
WorkCentre 5225, 5230
REP 16.2.1
Repairs and Adjustments
Launch Version
REP 16.2.1 SB-Finisher Undocking
Parts List on PL 23.1
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Switch off the power and disconnect the Printer power cord.
2. Disconnect the Finisher Power Cord, the H-Transport Connector and the Finisher Con-
nector from the IOT.
CAUTION
The Finisher is unstable when not docked with the Printer. Use care when handling an
undocked Finisher so that it does not fall over.
3. Release the Docking Latch on the Finisher and move the Finisher away from the Printer.
a. The docking latch is difficult to see when the Finisher is docked to the IOT. The figure
is shown with the finisher undocked to show the location of the latch and how to
actuate it.
b. Locate the docking latch from the rear of the Finisher and Printer. (Figure 1)
Figure 1 Locating the docking latch release (j0st41730.jpg)
c. With a large common screwdriver release the docking latch by moving the latch
toward the front of the Finisher and move the Finisher away from the Printer. (Figure
2)
T
he docking
l
atch release
f
rom the rear of
t
he Finisher and
P
rinter

Xerox WorkCentre 5225 Specifications

General

Maximum print size	A3 (297 x 420 mm)
Internal memory	No MB
Type	Digital copier