February, 2008
4-45
WorkCentre 5225, 5230
REP 7.3.4, REP 7.3.5
Repairs and Adjustments
Launch Version
Figure 11 Front Tray Cable details
Replacement
1. Install the front Tray Cable by carrying out the removal steps in reverse order.
2. Install the rear Tray Cable by carrying out the removal steps in reverse order.
3. Reinstall the HCF Tray’s Front Cover.
a. Make sure to raise the gear on the Indicator Shaft so that it meshes with the adjoin-
ing Lift Shaft gear.
b. Replace the (5) Installation Screws.
4. Reinstall the HCF Tray by lining up the rails of the tray with the adjoining rails of the HCF
and pushing the tray into place.
5. Place previously removed paper, or fresh paper, into the tray.
REP 7.3.5 HCF Retard / Feed / Nudger Rolls
Parts List on PL 18.5 PL 18.6
Removal
NOTE: Remove and replace the Retard/Feed/Nudger Rolls simultaneously.
WARNING
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Open the Feeder Top Cover of the HCF.
2. Release the green Lever to open the Upper Feeder Assembly to reveal the (3) rolls.
NOTE: For reference purposes, the single roll in the Upper Feeder Assembly is the
Nudger roll. The double roll in the Upper Feeder Assembly is the Feed Roll. The larger
double roll in the Lower Feeder component is the Retard Roll.
3. Remove each roll by squeezing the roll’s shaft at both ends (with the thumb and forefinger
of one hand) and lifting the roll up and out of the HCF. (Figure 1)
Figure 1 Removing rolls
To Next Page
Loading...
Need help?
General
