February, 2008
4-39
WorkCentre 5225, 5230
REP 7.3.3, REP 7.3.4
Repairs and Adjustments
Launch Version
NOTE: Make sure that the Caster of the copier/printer is rotated out of the way (fully
rotated underneath the copier/printer) so that it does not interfere with HCF docking.
3. Push the HCF into place against the copier/printer.
4. Reattach the HCF Power Cable to the left rear of the copier/printer.
REP 7.3.4 HCF Tray Cables
Parts List on PL 18.3
Removal
WARNING
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
PART 1 Removing the HCF Rear Tray Cables
1. Remove the HCF Tray (REP 7.3.1)
2. At the rear of the HCF Tray, remove the Gear Bracket Assembly. (Figure 1)
1. Remove (2) E-Rings securing the oval-shaped Plate and remove the Plate.
2. Slide the (2) gears, that were being retained by the Plate, off their shafts and set the
gears aside.
3. Remove (3) screws securing the Gear Bracket Assembly.
4. Remove the Gear Bracket Assembly, being careful to maneuver it around the cable
as required for removal.
To Next Page
Loading...
Need help?
General
