Information for the driver
Travel data display (
multi-function
display)
There are different instrument panels, hence
the versions and indications may vary.
The display is not displayed. In the case of
displays without information or warning messages,
anomalies are indicated only by means of control
tell-tales.
Some indications on the instrument panel
display may be obscured by
a sudden event, e.g. an incoming call.
Depending on the equipment, some settings
and indications can be made or displayed.
also in the infotainment system.
If there are several warnings, the
corresponding symbols shall light up one
after the other.
for a few seconds. The symbols shall remain lit until
the cause is eliminated.
If, when the ignition is switched on, warnings
about existing faults are displayed, it is
possible that a fault may have occurred.
It will not be possible to make adjustments or display
information as described. In this case, contact a
specialist workshop and have the malfunctions
repaired.
Please note at the beginning of this chapter on
page 16.
The trip data display (multi-function display) shows
the trip data and con- sum values.
Depending on the vehicle equipment, various trip
data can be displayed. The trip data displayed
depends on the current driving behaviour, the
condition of the vehicle (e.g. regeneration of the
particulate filter) and the current driving situation
(e.g. city driving, motorway driving, etc.). The trip
data are calculated by the
The average value may vary from the actual
value over different lengths. Therefore, the
actual value displayed may vary from the actual
average value.
Switching from one display to another
Vehicles with multifunction steering wheel:
—
Press the key or → p. 28.
Switch memory
Vehicles with multifunction steering wheel:
—
Press the button on the multifunction steering wheel.
→ p. 28.
Memory
From departure
If driving is interrupted for more than 2 hours, the
memory is deleted.
Memory
From refuelling
Display and storage of trip data
and the consumption values collected. When
refuelling, the memory is cleared.
Memory
Total calculation
This memory collects trip data up to a maximum of
19 hours and 59 minutes or 99 hours and 59
minutes, or up to a maximum of 1999.9 km.
or 9999.9 km. If one of these maximum values is
exceeded, the memory is cleared. The maximum
values vary depending on the version of the
instrument cluster.
Erasing travel data memories
Select the memory you want to delete.
Vehicles with multifunction steering wheel:
—
Press the button on the multifunction steering wheel.
→ p. 28.
Select the indications
In the infotainment system, in the vehicle settings
menu, you can set which trip data should be
displayed → p. 29.
Display
Average consumption
The average fuel consumption is displayed after
approx. 300 metres (984 ft).
Indication
Autonomy
Approximate distance in km that can still be covered
if the same driving style is maintained.
Indication
Autonomy AdBlue
or
Autonomy
Approximate distance in km that can still be covered
with the current
AdBlue®
tank level if the same
driving style is maintained. The display appears
from a lower range onwards.
at 2400 km (1491 miles) and cannot be deactivated.
Even if the outside temperature is above freezing,
there may be ice on roads and bridges.
•
The ice crystal symbol indicates that there
may be danger of frost.
•
At outside temperatures above +4 °C (+39
°F), ice may also be present even if the ice
crystal symbol does not light up.
•
Never rely on the outside temperature
display alone!
To Next Page
Loading...
Need help?
General
