Introduction to the topic
Unlocking and locking with the
"Keyless Access" system
Keyless Access" keyless
locking/starting system
The "Keyless Access" system allows the vehicle to
be unlocked and locked without the active use of
the key.
key. A valid vehicle key must be available in the
vicinity of the vehicle.
Fig. 58 Keyless Access system: proximity zones.
Fig. 59 On the handle: sensing surfaces.
—
Touch the sensor surface → fig. 59 on the
outside of the door handle.
Unlocking the vehicle is confirmed by a double
flashing of the direction indicators; locking is
confirmed by a single flashing of the direction
indicators.
Unlocking and locking the luggage compartment lid
When the vehicle is locked, the tailgate unlocks
automatically when it is opened if there is a vehicle
key in the vicinity of the tailgate → fig. 58.
After closing, the tailgate locks automatically.
If the whole vehicle is unlocked, the tailgate will
not lock automatically after closing.
Temporarily deactivate the "Keyless Ac-
cess"
system
To prevent unauthorised third parties from
unlocking and starting the vehicle, the Keyless
Access system can be temporarily deactivated as
follows:
—
Lock the vehicle using the key on the vehicle
key.
—
In addition, within 5 seconds, touch the sensor
on the outside of the door handle → fig. 59 B
once. When doing so, do not grip the handle.
—
The Keyless Access system is temporarily
deactivated.
—
Check deactivation by pulling the door handle
after at least 10 seconds. It should not be
possible to open the door.
The next time the vehicle can only be unlocked with
the vehicle key. After unlocking, the "Keyless
Access" system will be activated again.
Using the comfort functions
All power windows and the glass roof can be
closed automatically.
—
Hold a finger on the sensing surface
Unlocking and locking the vehicle
→ fig. 59
of the handle of the con- door
Unblock:
—
Touch the sensor surface → fig. 59
located
The driver's or passenger's seat for a few seconds
until the windows and roof have closed.
on the inner side of the door handle.
Block:
—
Switch off the ignition.
—
Close the door.
The functions of the sensor surfaces can be
set in
the
Vehicle settings
menu of the in-
fotainment
system.
To Next Page
Loading...
Need help?
General
