—
IUF: Seat suitable for the installation of an ISOFIX
child seat with "univer- sal" approval.
—
i-U: Seat suitable for the installation of an i-Size
forward-facing or rearward-facing child seat
with "universal" approval.
—
i-UF: Seat suitable for the installation of an i-Size
forward-facing child seat with "universal"
approval.
—
i-B: Seat suitable for the installation of a
forward-facing ISOFIX group 2/3 booster
cushion and a forward-facing i-Si- ze child seat
for children with a height between 100 and 150
cm (approx. 39 cm).
and 59 inches).
Fitting an ISOFIX or i-Size child seat
Fig. 45 Marking of ISOFIX anchorage points for
child seats.
Fig. 46 Marking of ISOFIX anchorage points for
child seats.
Fig. 47 Marking of i-Size anchorage points for child
seats.
Fig. 48 Schematic representation: assembly of a child
seat with connectors.
The location of the ISOFIX or i-Size anchorage
points is indicated by a symbol → fig. 45, → fig. 46
o → fig. 47.
—
Please note and follow the instructions
→ p. 54.
—
If necessary, remove the protective caps from
the ISOFIX or i-Size anchorage points.
—
Insert the child seat connectors into the ISOFIX
or i-Size anchorages in the direction of the arrow
→ fig. 48. The child seat must be securely and
audibly locked.
—
Pull on both sides of the child seat to check
that it is correctly fitted.
If the child seat is equipped with a support leg, the
support leg must be firmly attached to the vehicle
floor.