Installazione sul veicolo
Installation
1. Temporarily fit the alternator to the engine with
two fixing bolts.
2. Fit the alternator belt.
3. Regulate the belt bending so that, by applying a
pressure equivalent to 98 N (10 kg-f), at the central
point between the water pump pulley and the al-
ternator pulley, this results as follows
4. Fix cable B (+) and the alternator connector.
5. Reconnect the ground lead terminal to the bat-
tery negative (-) terminal.
N.B.
- A NEW BELT IS A BELT WHICH HAS BEEN USED LESS
THAN 5 MINUTES.
Characteristic
Bending:
New belt: 5.0-7.0 mm
Belt used: 6.0-8.0 mm
Power lock
Air filter
CENTRAL LOCKING WITH REMOTE CONTROL
SYSTEM DESCRIPTION
The Piaggio system 612697 is an electronic device which allows the simultaneous activation of vehicle
door locks (central locking). The central locking, can be activated in two different modes:
- Manual - Radio-controlled
The activation of the central locking via remote control is signalled by a differentiated switch-on of the
turn indicators. For central locking of locks, the Piaggio device 612697 is equipped with a remote control
working via radio with a frequency type-approved to operate at 433.92 Mhz. A safety device integrated
to the system blocks central locking activation with the remote control while the vehicle is moving.
Electrical system PORTER 1.3 16V
ES - 126
To Next Page
Loading...
Need help?
General
