PIAGGIO PORTER 1.3 16V 2008 User Manual

This function allows users to deactivate the device if the radio controls do not work or are lost.
The PIN-CODE provided comprises four numbers between 1 and 9. These digits, with 1-1-1-1 as the
factory default code, are the same in all the alarms of 7563 series and similar. For safety reasons,
change the code, by personalising it with a code chosen by the user.
For the new pin-code program specifications follow the indications contained in the relevant section
(page 12).
8. Alarm memory
If the turn indicators flash five times and the siren sounds five times when the alarm is deactivated,
thanks to the LED memory, the cause which has generated the last alarm condition can be identified.
To do so, turn the starter key to "ON" and watch the status LED, which starts flashing, indicating the
last cause of alarm. The visual signal will be repeated for 5 times and can be interrupted simply by
turning the starter key to "OFF".
The possible alarm warnings are indicated in the following diagram.
LED WARNING
Specification Desc./Quantity
*O* Absorption sensor (5 cycles)
**O** Start-up tried (+15/54) (infinite cycles)
***O*** Door switch (5 cycles)
****O**** Cable cut (infinite cycles)
*****O***** External wire sensor bonnet/trunk switch (5 cycles)
******O****** Magnetic contact via radio (5 cycles)
*******O******* Infrared sensor via radio (5 cycles)
*= ON - 1 second
O= OFF - 2 seconds
Garage function.
This function is useful if it is necessary to deactivate the alarm, for example, due to maintenance, without
intervening on the programming performed.
In fact, this function deactivates the alarm completely without activating the anti-distraction function and
passive function.
To do so, follow the short procedure described below:
•
With the alarm deactivated, turn the ignition key to "ON".
•
The LED turns on for a short time (0.5 ").
•
During that period, insert the electronic key in the appropriate hole.
•
The LED turns off, indicating the alarm deactivation.
•
To restore the regular functions, activate the alarm with the radio control.
PORTER 1.3 16V Electrical system
ES - 135

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English