PIAGGIO PORTER 1.3 16V 2008 User Manual

IT IS NECESSARY THAT THE ELECTRICAL CONNECTIONS REQUIRED ARE CARRIED OUT
(DOOR SWITCH, BONNET SWITCH AND LIVE POSITIVE) SO THAT THE OPERATION HAS A
POSITIVE OUTCOME.
Control devices can be deleted from the alarm, such as radio controls, electronic keys, TAG cards,
magnetic contacts or infrared sensors (the latter as protection devices).
The procedure to carry out this operation is described below.
•
With the alarm deactivated, open and keep both the bonnet and the driver side door open.
CAUTION
THE "ON-OFF" OPERATIONS ARE CARRIED OUT WITHIN A MAXIMUM TIME OF FOUR SEC-
ONDS. IF THESE STEPS ARE NOT FOLLOWED, THE PROCEDURE TO DELETE DEVICES THAT
ARE IN THE MEMORY IS CANCELLED.
•
Turn the vehicle ignition key "ON".
•
Turn the vehicle ignition key "OFF".
•
Take the ignition key back to "ON" three times (ignition key "ON" and "OFF") and, as de-
scribed above within a period of four seconds.
•
The fourth time the ignition key is switched to "ON", leave it in that position.
•
The alarm signals the annulment of the control devices, magnetic contacts or infrared sen-
sors by means of two turn indicator flashes and two sound alarms, a high-pitched one and
a grave tone one.
•
Close the bonnet; the status LED remains steadily on
•
Leave the bonnet closed until, after about four seconds, the radio devices are completely
deleted.
IF THE VEHICLE BONNET IS CLOSED FOR LESS THAN FOUR SECONDS THE DELETION OF
RADIO DEVICES CAN NOT BE OBTAINED .
•
Deletion is signalled by the turning off of the status LED, a long flashing of turn indicators
and a sound alarm with grave tonality.
•
Turn the vehicle ignition key "OFF".
PROGRAMMED FUNCTIONS ARE NOT MODIFIED BY DELETING CONTROL DEVICES.
NEW PIN-CODE PROGRAMMING
Find below the procedure to personalise the PIN-CODE which, as previously described, is useful to
personalise the coded at the customer's will. In the example shown you want to enter a code with the
digits 5-4-6-7.
•
When the system is deactivated, open and keep the vehicle driver side door open.
•
Turn the ignition key to "ON".
•
The status LED turns on for 0.5 seconds. during that time, press both radio control keys at
the same time.
•
Following this operation, there are two sound alarms, a high-pitched one and a grave tone
one.
•
Close again the driver side door previously opened.
Electrical system PORTER 1.3 16V
ES - 146

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English