To Next Page

To Previous Page

Engine oil change and filter replacement

1. Shut off the engine after warming it up for a few

minutes; remove the protection cover;

2. Remove the oil drainage plug and empty the

engine sump;

3. Remove the oil filter with a suitable wrench;

4. Check and clean the filter fitting surface.

5. Apply engine oil on the sealing ring of the new

filter before fitting it.

6. Finger screw the oil filter until the sealing ring

makes contact with the filter fitting surface.

7. Tighten the oil filter 3/4 of a turn with a filter

wrench

8. Clean the oil drainage plug. Fit the plug and

place a new gasket in between.

- REMOVE GASKET WASTE OFF THE OIL SUMP USING A

SUITABLE SCRAPER.

9. Pour oil in the engine until the maximum level in

the oil dipstick is reached.

10. Start the engine and check that there are no

leaks.

11. Stop the engine.

12. Check the level again and top up, if necessary.

Leaks

Check that there are no oil leaks from the gasket.

Gear-box oil replacement

Sostituzione olio cambio

Gearbox oil change

1. Remove the drainage plug and the filler cap.

Drain the gearbox oil.

2. Refit the drainage plug and place a new gasket in between.

3. Top up with recommended oil until it starts to come out through the fill opening.

PIAGGIO PORTER 1.3 16V 2008 User Manual

Questions and Answers: