PIAGGIO PORTER 1.3 16V 2008 User Manual

•
Select a piston that has the same type
of cylinder coupling E.
N.B.
- THE COUPLING TYPE «E» IS INDICATED ON THE PISTON
CROWN.
Crankcase bearings
Oil sealing rear gasket replacement
1. Rear sealing ring removal.
Remove the sealing ring from the flange, using a
punch.
N.B.
- BE CAREFUL NOT TO DAMAGE THE SEAT WHERE THE
SEALING RING IS FITTED.
2. Rear sealing ring fitting.
Insert a new ring using in the seat with the follow-
ing special tool.
N.B.
- BE CAREFUL THAT THE RING IS NOT FITTED DIAGO-
NALLY.
- THE SPECIAL TOOL IS DESIGNED TO CARRY OUT THE
INSTALLATION ALSO WHEN THE FLANGE IS FITTED ON
THE ENGINE.
Specific tooling
020383Y Punch for flywheel fitting
Timing side oil sealing ring replacement
1.Sealing ring removal.
Remove the sealing ring from the oil pump, using
a punch.
- BE CAREFUL NOT TO DAMAGE THE OIL PUMP DURING
FITTING.
Engine PORTER 1.3 16V
EN - 314

PIAGGIO PORTER 1.3 16V 2008 Specifications

General

Brand	PIAGGIO
Model	PORTER 1.3 16V 2008
Category	Automobile
Language	English