•
Take out exhausted batteries and re-
place them with new ones, paying at-
tention to observe polarity.
•
Refit the magnetic contact cover.
USE ONLY CR1616 TYPE BATTERIES
Open the TAG plastic using the crack located near
the slot by levering with a screwdriver. Take out
the circuit and slide off the discharged battery; fit
the charged battery holding the positive pole fac-
ing upwards. Refit the whole unit being careful that
it closes properly and effectively.
USE ONLY CR2032 TYPE BATTERIES FOR A LONGER
LIFE OF THE BATTERY TURN THE DEVICE OFF DURING
THE PERIODS OF INACTIVITY.
2. Radio control
To prevent remote control operation failures, the
latter has inside a device that indicates the battery
charge status. When using the radio control regu-
larly, press the control switch and the green warn-
ing LED turns on to remain steadily on. In case the
radio control battery charge status should de-
crease below the standard level in order to guar-
antee proper operation, by pressing the system
activation/deactivation switch, the green warning
LED turns on flashing, warning the user that it is
necessary a battery replacement.
USE ONLY CR1616 TYPE BATTERIES
3. Infrared sensor
When the battery voltage decreases below 5.5V, before reaching the minimum charge level for oper-
ation, the sensor signals such condition.
PORTER 1.3 16V Electrical system
ES - 149
To Next Page
Loading...
Need help?
General
