Engine housing inspection
Battery connections
Check the following:
- Corrosion or slackness of connections.
- Battery terminals detached due to slackness.
Tighten connections or the terminal, if necessary.
Battery fluid
Check the level:
- Add distilled water up to the upper level if neces-
sary.
- The electrolyte specific weight shall exceed 1.25
at 20°C.
Bellow joint
Sleeve connections and fluid pipes
Check the sleeve and fluid pipe connections.
- Check that there are no signs of leaks in the coolant pipes.
- Check that the hoses and the air inlet duct are properly connected.
Ignition timing
IGNITION TIMING - CHECKING AND ADJUSTMENT
- BEFORE CARRYING OUT THE IGNITION TIMING, CONNECT THE TESTER MULTIMETER
PROBE WITH THE DIAGNOSIS CONNECTOR GROUND TERMINAL.
- THE ENGINE SHALL NOT EXCEED THE INDICATED SPEED. BESIDES, OPERATE SO THAT
THE IGNITION TIMING IS STEADY.
1. Warm up the engine;
2. Connect the rpm indicator terminal to the diagnosis connector.
- AVOID CONTACT BETWEEN THE RPM INDICATOR TERMINAL AND GROUND SO AS NOT TO
DAMAGE THE ELECTRONIC CONTROL UNIT OF THE ELECTRONIC FUEL INJECTION AND/OR
THE IGNITION COIL.
- TAKING INTO ACCOUNT THAT SOME RPM INDICATORS ARE NOT COMPATIBLE WITH THIS
IGNITION SYSTEM, IT IS RECOMMENDED TO CHECK THE RPM INDICATOR COMPATIBILITY
WITH THE SYSTEM BEFORE ITS USE.
Pre-delivery PORTER 1.3 16V
PD - 806
To Next Page
Loading...
Need help?
General
